ECS GeForce GTX 560 -
Product Showcase
Two 6-pin PEG power connectors are required for this board. Power consumption is rated at roughly 170W TDP for the reference design 1024MB model, the TDP as we measured it, is in fact a fraction higher due to the factory overclock. The power-connectors have been seated along the top side of the graphics card.
As you can see, the card is equipped with three connectors, two dual-link DVI connectors and one mini-HDMI connector. The cooler tries to exhausts hot air through the upper mesh as much as it can.
Here we have the backside, the PCB is clean and has a fairly uncomplicated design. Make note of the fact that there is just one SLI connector to be found, only allowing two cards to be set up in multi-GPU mode. Definitely a decent looking card, though a black PCB would have been one notch nicer IMHO.
The GeForce GTX 560 we'll review in this article comes from ECS, out of the three products GTX 560 tested today here on Guru3D.com this one is reference clocked, has a reference design and a reference cooler. So this product will be the baseline performance product. Now that does not mean a sober product contrary, baseline performance is pretty good for the money. And next to that, we all know you'll gain the most from the less expensive products one you go and tweak them.
ECS GeForce GTX 460 Black review
We review the ECS GeForce GTX 460 Black series. Within the entire scope of Fermi GPU based graphics cards from NVIDIA the GeForce GTX 460 has to be the most interesting in terms of value for money with very acceptable decent thermals and power consumption. This is why we see a lot of SKU's released for this product, with a variety of cooling and factory overclocks. ECS Elite group also release a handful of GeForce GTX 460 cards, based on the reference design, slight overclock yet also a BLACK series graphics card which is a factory overclocked model with an Arctic cooling Accelero Xtreme PRO cooler sitting on top of that GPU.
ECS GeForce GTS 250 1024MB review | test
ECS GeForce GTS 250 tested -- Today the turn goes to the folks at ECS. Ever since the past year or two they have been trying hard to get a grip in the e-tail and retail channel, and as a brand they certainly are growing. With a creative product design and marketing team they present us some fairly special designs and concepts. Today's product tested is not at all different. Though we'll stubble into a reference clocked product, there is very little little reference otherwise.
ECS GeForce 9800 GTX+ Hydra SLI
A review on the ECS GeForce 9800 GTX+ Hydra SLI. Basically you'll receive two pre-modified GeForce 9800 GTX+ products and a water-cooling kit that is supplied by Thermaltake. It's in fact the Thermaltake big water series that you can slide into you 5.25"drive bay easily. Pretty much the only thing you need to do is connect four tubing connections, fill her up, connect some wiring ... and you are good to go. That's 15 minutes tops to get a gaming performance level better than the GeForce GTX 280.