SATA 6G (SATA 3), the latest revision of your SATA storage unit connectors, will increase the bandwidth on the SATA controller from 3 GBit/sec towards 6 GBit/sec. For a regular HDD that is not really very important. But with the tremendous rise of fast SSD drives this really is a large plus. Typically we get 3000 Mbit/s : 8 = 375 MB/sec bandwidth minus overhead, tolerances error-correction and random occurrences.
SATA 3 is doubling it up, as such we get 6000 Mbit/sec : 8 = 750 MB/sec (again deduct overhead, tolerances error-correction and random occurrences) of available bandwidth for your storage devices. As you can understand, with SSDs getting faster and faster that's just a much warmed and welcomed increase in bandwidth.
Put Sata III in RAID and you'll have even more wicked performance at hand. Most motherboards only offer two ports per controller though, so you are (for now) limited to RAID 0 and RAID 1 (mirror or stripe).
Also there are two controllers currently being used for mainstream, currently the Sandy Bridge P67 platform offers the highest performing solution. Though still fast, any platform using the Marvell 9128 or 9130 will see lower performance scores as the Marvell controllers use a PCI-Express Gen2 x1 lane interface to the system which restricts performance a little. The internal processor in that chipset also limits IOPS by the way.
The one thing SSD and HDD manufacturers are quite horrible at, is to show you the real number of GB your drive has AFTER formatting. With 25nm NAND flash memory based products, it even gets worse as the SSD will need to reserve a chub of NAND memory for provisioning as well.
Say that you purchase a 120 GB SSD drive, people expect to get 120GB and not 115 GB, you can dwell down into the "Windows uses Binary capacity measurements 1024MiB = 1GiB" discussion, but it remains somewhat shady advertising.
With 25nm NAND flash memory some more than usual NAND FLASH will be hogged up by the SSD for redundancy and compression and so its over-provisioning a few additional GB.
The end result for a 240 GB SSD is 223 GB after the NTSF format.
For a 120GB SSD we see 111 GB available after the format. So on average you'll miss out roughly 8% right there, without the drive even being used for storage.
Corsair Vengeance RGB DDR4 memory review In this article we review the new RGB series Vengeance DDR4 memory from Corsair. Not only do these puppies look awesome, they are properly specced as well. We received a 4x8GB DDR4 3000MHz CAS 15 DRA...
Corsair Gaming K95 RGB PLATINUM review Corsair just released the K95 RGB Platinum edition mechanical keyboard with Cherry MX speed switches. Combined with updated CUE software and a nice RGB overhaul this keyboard has been updated to what ...
Corsair Gaming SCIMITAR PRO RGB game mouse review This one is for the players, the PRO MMO gamers out there. Corsair releases the new PRO model Gaming SCIMITAR RGB game mouse with an improved sensor, a 16,000dpi Optical Sensor! The looks remain the...
Corsair Force MP500 480GB M2 NVMe SSD review In this review we test the Corsair Force MP500 480GB M2 NVMe SSD. Corsair is in full attack modus to make your PC even faster with this affordable yet seriously fast M.2 units which use the nvm expres...