XFX GeForce 9600 GT XXX 512MB review

Graphics cards 1048 Page 5 of 15 Published by

teaser

5 - GPU temps, power consumption & noise levels

 

Power consumption

We'll now show you some tests we have done on overall power consumption of the PC. Looking at it from a performance versus wattage point of view, the power consumption is not as bad as I expected it to be. The card according to NVIDIA has a TDP of ~95 Watts.

Our test system contains a Core 2 Duo X6800 Extreme Processor, the nForce 680i mainboard, a passive water-cooling solution on the CPU, DVD-rom and a WD Raptor drive. The results:

  • PC in Idle = 177 Watt
  • PC 100% usage (wattage gaming Peak) = 238 Watt

The methodology is simple: We have a device constantly monitoring the power draw from the PC. After we have run all our tests and benchmarks we look at the recorded maximum peak; and that's the bulls-eye you need to observe as the power peak is extremely important. Bare in mind that you are not looking at the power consumption of the graphics card, but the consumption of the entire PC.

The monitoring device is reporting a maximum system wattage peak at roughly 240 Watts with a GeForce 9600 GT card installed, and that is not excessive at all. So here's my power supply recommendation:

  • A single GeForce 9600 GT requires you to have a 450 Watt power supply unit at minimum if you use it in a high-end system. That power supply needs to have (in total) at least 26 Amps available on the 12 volts rails.
  • A second GeForce 9600 GT installed on this system requires you to have a 500 Watt power supply unit at minimum if you use it in a high-end system. That power supply needs to have (in total) at least 36 Amps available on the 12 volts rails.

There are many good PSU's out there, please do have a look at our many PSU reviews as we have loads of recommended PSU's for you to check out in there. What would happen if your PSU can't cope with the load?:

  • bad 3D performance
  • crashing games
  • spontaneous reset or imminent shutdown of the  PC
  • freezes during gameplay
  • PSU overload can cause it to break down

Noise Levels coming from the graphics card

When graphics cards produce a lot of heat, usually that heat needs to be transported away from the hot core as fast as possible. Often you'll see massive active fan solutions that can indeed get rid of the heat, yet all the fans these days make the PC a noisy son of a gun. I'm doing a little try out today with noise monitoring, so basically the test we do is extremely subjective. We bought a certified dBA meter and will start measuring how many dBA originate from the PC. Why is this subjective you ask? Well, there is always noise in the background, from the streets, from the HD, PSU fan etc etc, so this is by a mile or two not a precise measurement. You could only achieve objective measurement in a sound test chamber.

The human hearing system has different sensitivities at different frequencies. This means that the perception of noise is not at all equal at every frequency. Noise with significant measured levels (in dB) at high or low frequencies will not be as annoying as it would be when its energy is concentrated in the middle frequencies. In other words, the measured noise levels in dB will not reflect the actual human perception of the loudness of the noise. That's why we measure the dBA level. A specific circuit is added to the sound level meter to correct its reading in regard to this concept. This reading is the noise level in dBA. The letter A is added to indicate the correction that was made in the measurement. Frequencies below 1kHz and above 6kHz are attenuated, where as frequencies between 1kHz and 6kHz are amplified by the A weighting.

table_tl.gif

 

table_tr.gif
blank.gif
TYPICAL SOUND LEVELS
Jet takeoff (200 feet) 120 dBA  
Construction Site 110 dBA Intolerable
Shout (5 feet) 100 dBA  
Heavy truck (50 feet) 90 dBA Very noisy
Urban street 80 dBA  
Automobile interior 70 dBA Noisy
Normal conversation (3 feet) 60 dBA  
Office, classroom 50 dBA Moderate
Living room 40 dBA  
Bedroom at night 30 dBA Quiet
Broadcast studio 20 dBA  
Rustling leaves 10 dBA Barely audible
blank.gif
table_bl.gif blank.gif table_br.gif

We tested all cards on dBA levels. Obviously the reference coolers all perform roughly the same. The customized coolers are either louder or softer depending on what they try to achieve. Here are the results:

table_tl.gif

 

table_tr.gif
blank.gif

Graphics card

IDLE

During Gaming

9600 GT 512MB NVIDIA

 38

42

9600 GT 512MB XFX XXX

 38

42

blank.giftable_bl.gif blank.gif table_br.gif

You'll notice that all cards perform roughly the same and the reference cooler are doing a pretty nice job. During gaming when the heat builds up in the GPU, the fans will start to spin faster and create more airflow. So in IDLE this is what our PC created noise wise, expect that level of noise in for example desktop mode.

Let's have a look at the temperatures.

XFX GeForce 9600 GT XXX core temperature

Let's have a look at the temperatures these single slot design coolers produce.

table_tl.gif

 

table_tr.gif
blank.gif XFX GeForce 9600 GT XXX edition blank.gif
table_bl.gif blank.gif table_br.gif

The XFX GeForce 9600 GT XXX.

  • GPU Idle - 44 Degrees C
  • GPU under full load 64 Degrees C

This product has exactly same cooler as the reference design, though a faster clock should make the temps rise a little. We measure at a set 21 Degrees C room-temperature. All in all, fine results

Share this content
Twitter Facebook Reddit WhatsApp Email Print