Noctua NH-C14S Low Profile CPU cooler review

Cooling 189 Page 8 of 10 Published by

teaser

Core i7 4790K OC at 4600 MHz 1.3 Volts

Now we up the ante. Understand that 1.3V and higher voltages are the levels where Haswell processors get into serious problems due to the aforementioned heat-spreader versus TIM design applied solution from Intel. We now set the Core i7 4790K @ 4600 MHz and apply 1.30 volts on the CPU while loading it with 100% stress for wPrime to run on all available CPU threads three times.

Core i7 4790K OC at 4600 MHz 1.3 Volts - IDLE 

Below, you can see the IDLE results with the Core i7 clocked at 4790K @ 4600 GHz with 1.30 volts on the CPU. Again, the results are the IDLE temperatures thus you are in your desktop doing pretty much nothing. 

 Untitled-3

Core i7 3770K OC at 4600 MHz 1.3 Volts LOAD

Now we'll be testing the temperatures under fully threaded stress. If we set the overclock at 4600 MHz and configure CPU Voltage at 1.3V, these are the results.  


Untitled-4

The temps normally rise above and beyond 90 Degrees C for a lot of heatpipe based coolers, which is a definitive no-no. As you can see, we have dangerous temperatures for most coolers. Very few coolers and kits can actually manage a Core i7 4970K @ 1.3+ Volts / 4600+ MHz temperature wise well enough. The Noctua is keeping thins relatively cool, not at all bad for heatpipe based cooling really.


130v

We run wPrime 2 times, at the last run we measure the peak temperature which was ~76 Degrees with a Core i7 4790K and 1.3 Volts in the CPU. The overall temp is borderline recommended for long term stability, for that it'll need to be below ~75 Degrees C.

Extended Tweaking

Since this solution harbors a lot of extra cooling capacity I extended overclocking to higher voltages as well. 

Untitled-5


The above numbers are just for reference only e.g. how does a 4790K behave with increased voltages at a 4600 MHz clock frequency. We can run the unit towards 1.40 Volts on the processor (which is a lot for this CPU!). At this stage the system still boots and can finish two wPrime stress runs. Typically at 1.35~1.40 Volts and a good enough processor, you are in the 5 GHz range (if your CPU is capable). 

After 1.35 Volts the fans will start to spin a notch faster though 38 DBa is a very good and normal airflow level from an audible point of view. At 1.40 Volts in the CPU the processor starts to overheat and here things will become more noisy. 

140v

Share this content
Twitter Facebook Reddit WhatsApp Email Print