Specifications and Features
Trident Z F4-3200C14Q-32GTZ (8GBx4)
So the memory kit tested today comes from that G.Skill TridentZ series armed with the very best ICs all packed nicely under heat spreader design of the DIMM module. First things first, this kit is specifically optimized for 6th and 7th Gen Intel Core processors (Skylake / Broadwell-E) and the X99 / Z170 chipset.
- Trident Z is the latest high-performance DDR4 range from G.Skill, designed for gaming and overclocking
- Optimized for the latest 5th / 6th Generation Intel Core Processors and X99 / Z170 chipsets
- Four matched 8GB modules, designed for use in a dual or quad channel setup
- 3200 MHz memory speed with full memory timings of CL 14-14-14-34-2N at 1.35V
- Two-colour heatsinks with a new fin design for more effective heat dissipation
The flagship of the TridentZ series actually clocks in at a rate of upto even 4000 MHz these days, we'll do just fine with the 3200 MHz CL14 kit though, as well as memory voltage of 1.35 volts for that 3200 MHz.
|
|
|
| Series | Trident Z |
| Memory Type | DDR4 |
| Capacity | 32GB (8GBx4) |
| Multi-Channel | Dual/Quad Channel Kit |
| Tested Speed | 3200MHz |
| Tested Latency | 14-14-14-34-2N |
| Tested Voltage | 1.35v |
| Registered/Unbuffered | Unbuffered |
| Error Checking | Non-ECC |
| SPD Speed | 2133MHz |
| SPD Voltage | 1.20v |
| Fan lncluded | No |
| Height | 44 mm / 1.73 inch |
| Warranty | Limited Lifetime |
| Features | Intel XMP 2.0 (Extreme Memory Profile) Ready |
DDR4 entry-level SKUs are clocked at 2133 MHz, but often with better access times and 2133 MHz runs at stock 1.2 volts which is also a tad lower. Pricing wise you can spot this 32GB kit for € 240,- which is €7,50 per GB. All modules are equipped with a new style heatspreader that holds with Thermal Conductive Technology. The memory chips have contact with the heat sink in order to ensure that both memory and the board operate at the same temperature and can thus provide the best performance. Once installed in the BIOS if supported, select the XMP profile for the memory and after a reboot you are good to go -- really it's that simple. If you do not have an XMP profile option in your BIOS, set the timings manually and set DIMM voltage a little higher to 1.35V opposed to an SPD 2133 MHZ config with 1.2 Volts.
But head on over to the next page where we'll startup a product photo-shoot after which this article will dive into a benchmark session. Hey, we know you like it like that!
