Fractal Design Core 3300 review

PC Cases and Modding 229 Page 3 of 8 Published by

teaser

Product Showcase

Img_9693

When we flip around the unit we can see the side panel a little better. Very simple with a mesh where you can install an additional fan. There are a total of 7 fan slots, and two silent Series R2 140 mm fans have been pre-installed. The chassis can support up to a 240mm radiator. The panel can be removed by removing two thumbnails at the back and then pulling it towards you. It is the old traditional way of chassis panel removal. 

Img_9694

The backside then. Next to the rear IO we spot that 140mm fan. All two fans in this chassis can be PWM fan controlled, however a fan controller is not included. Obviously if supported you can have your motherboard regulate FAN speed. The Core 3300 has 7 card slots.

11110_img_9692

Here we can see the left side panel, with the same locking mechanism. Two thumbscrews at the rear secure it down. The matte black paint job is a bit sensitive to scratches, by the way. 

Share this content
Twitter Facebook Reddit WhatsApp Email Print