And here's the PCB, daunting to look at as it's much smaller than I expected. This 6Gbps storage unit makes use of Sandisk 24nm MLC Toggle NAND. And there it is, on the left the SandForce 2281 controller can be seen, owned by LSI these days.
At total of 16 NAND flash memory ICs (8 on each side) are fixed onto the PCB. The NAND FLASH partition are assigned to the SandForce 2281 controller.
The SandForce 2281 controller
SandForce, opposed to other controllers, enforces a trick as they can write to the FLASH memory less then the competition needs to by using real time compression. The SF controllers store a representation of your data and not the actual data itself. It does that by using a partition of the available NAND flash memory.
This is why on SandForce based drives you do not see an extra memory cache chip, which in fact saves on the bill of materials used for the SSDs, it will however make your available storage volume smaller, as Sandforce uses some of the NAND flash for compression.
The SF-2281 series controller will support up to say roughly 500MB/s sequential read and write speeds, that's a good 62.5MB/s per one of the available eight channels. Combined the bandwidth is just exceptional for single non RAID drive.
SF2281 controllers support TRIM. Deduct a few GB per partition for real-time data compression and then you have your SSD ready.
The one thing SSD and HDD manufacturers are quite horrific at is to show you the real number of GB your drive has AFTER formatting.
With 25nm NAND flash memory based products it even gets worse as the SSD will need to reserve a chub of NAND memory for provisioning as well. Say that you purchase a 120 GB SSD drive, people expect to get 120GB and not 115 GB, you can dwell down into the "Windows uses Binary capacity measurements 1024MiB = 1GiB" discussion, but it remains somewhat shady advertising.
With NAND flash memory verys SandForce some more then usual NAND FLASH will be hogged up by the SSD for redundancy and compression and is over-provisioning a few additional GB.
The end result for our 240 GB SSD is 223 GB after the NTSF format. We lost almost 7% = 17 GB right there without the drive even being used for storage.
Corsair Hydro H5 SF review We test and review the all new Corsair Hydro H5 SF Liquid cooler. Now if you think that the product is a strange looking contraption, well it is! But for good reason, this is the first ever AIO liqui...
Corsair Carbide Quiet 400Q review The latest in the Carbide series of PC cases from Corsair would be the 400Q and 400C. The C (Clear) model comes with a see through side panel while the Q model (Quiet) is aimed at silence. It is exact...
Corsair Carbide Series Clear 600C review We review the new The Carbide Series Clear 600C from Corsair. This new chassis in the Carbide series is totally unique in design as it makes use of a reversed ATX form factor. Pretty much you flip ...